FD10

Aluminum or polycarbonate infill cover set with a 780mm length. Used to fill gaps in partial cover systems, improving visual appearance and protecting mechanical parts.

Combined safety kit with 350mm and 700mm infrared 4SAFE units. Used where varied coverage is needed at top/bottom of the door leaf.

Sensor kit combo including both 350mm and 900mm 4SAFE modules. Allows tiered safety zones for advanced swing door applications.

Compact 350mm-range sensor kit for swing doors. Ideal for narrow leaf or limited field of detection requirements.

Medium-range swing door safety sensor kit (700mm). Balances range and compact form factor.

Dual-sensor 4SAFE safety kit (900mm range), black finish, for swing doors. Provides infrared presence detection to meet EN 16005 standards.

High-range (900mm) presence and motion sensor for swing door edges. Infrared curtain pattern ensures accurate obstruction detection.

12mm shaft extension for adjusting spindle-arm interface length. Used to fine-tune drive rod positioning or accommodate offset leaf hardware.

20mm extension for drive spindle. Useful in adjusting for custom leaf depths or non-standard mounting conditions.

Intermediate 30mm axle extender; balances reach and torsional stress. Designed for installations where mounting offset needs to be bridged.

Long-format 40mm extension piece for motor output shaft. Ensures proper articulation in extended-leaf setups.

Maximum-length (50mm) spindle extension; for deep-profile doors or when mounting point is set back from spindle axis.

Primary mechanical retainer for rods or arms; secures to sliding channel or output shaft. Precision-machined for torque load retention under dynamic conditions.

Digital access control module for Gilgen door systems. Integrates with FD20 via secure I/O for entry management.

Complete D-Bedix access unit with flush-mount back box. Weather-resistant housing and prewired for direct integration with door controller.

Complete kit for mounting the door leaf to the operator arm system. Includes spacers, brackets, and fixings to accommodate standard FD10/FD20 arm assemblies.

Spacer used to align sliding rod within drive channel. Ensures correct contact and avoids mechanical play or misalignment.

Drive motor and transmission assembly specific to FD10 series swing door operators. Features DC drive motor with torque-optimized gearbox for compact installations.

Gliding element designed for RG-type sliding rod assemblies. Provides low-friction linear movement along the track, ensuring smooth articulation during opening and closing cycles.

Protective enclosure cover for housing mechanical components (e.g., motor, drive rod). Designed to shield internal components from dust and unauthorized access.

Complete side cover assembly including fasteners and end closures. Designed for full-length protection of drive and mechanical elements in swing door systems.

RG-type sliding rod for pull-arm setups, specifically for right-opening inward doors. Sliding feature reduces wear in high-cycle applications.

Right-hand standard rod for push arm configurations (RS-type). Ensures correct door swing in right-opening installations.

Sliding drive rod for pull arm installations. Allows axial movement during opening/closing cycle. Optimized for inward-opening doors, reducing resistance and stress on the door leaf.

Travel limit stop for RG-type pull arm configuration. Aligns with sliding track to ensure repeatable stop behavior.